Stability of source mechanisms inverted from P‐wave amplitude microseismic monitoring data acquired at the surface     

Tijmen Jan Moser 《Geophysical Prospecting》2014,62(3):475-490

We study the stability of source mechanisms inverted from data acquired at surface and near‐surface monitoring arrays. The study is focused on P‐wave data acquired on vertical components, as this is the most common type of acquisition. We apply ray modelling on three models: a fully homogeneous isotropic model, a laterally homogeneous isotropic model and a laterally homogeneous anisotropic model to simulate three commonly used models in inversion. We use geometries of real arrays, one consisting in surface receivers and one consisting in ‘buried’ geophones at the near‐surface. Stability was tested for two of the frequently observed source mechanisms: strike‐slip and dip‐slip and was evaluated by comparing the parameters of correct and inverted mechanisms. We assume these double‐couple source mechanisms and use quantitatively the inversion allowing non‐double‐couple components to measure stability of the inversion. To test the robustness we inverted synthetic amplitudes computed for a laterally homogeneous isotropic model and contaminated with noise using a fully homogeneous model in the inversion. Analogously amplitudes computed in a laterally homogeneous anisotropic model were inverted in all three models. We show that a star‐like surface acquisition array provides very stable inversion up to a very high level of noise in data. Furthermore, we reveal that strike‐slip inversion is more stable than dip‐slip inversion for the receiver geometries considered here. We show that noise and an incorrect velocity model may result in narrow bands of source mechanisms in Hudson's plots.  相似文献   

Source speciation resolving hydrochemical complexity of coastal aquifers     

《Marine pollution bulletin》2014,78(1-2):118-129

There is a growing concern of seawater intrusion to freshwater aquifers due to groundwater overexploitation in the eastern coastal belt of Southern India. The problem becomes complex in the regions where industrial effluents are also contaminating the freshwater aquifers. In order to understand the hydrochemical complexity of the system, topographic elevation, static water level measurements, major ion chemistry, ionic cross plots, water type contours and factor analysis were applied for 144 groundwater samples of shallow and deep sources from Quaternary and Tertiary coastal aquifers, located within the industrial zone of 25 km² area near Cuddalore, Southern India. The ionic cross plots indicates dissolution of halite minerals from marine sources and seawater mixing into inland aquifers up to the level of 9.3%. The factor analysis explains three significant factors totaling 86.3% of cumulative sample variance which includes varying contribution from marine, industrial effluent and freshwater sources.  相似文献   

Distribution and source of heavy metals in the surface sediments from the near-shore area,north Jiangsu Province,China   总被引：1，自引：0，他引：1  

Gang Xu  Jian Liu  Shaofeng Pei  Xianghuai Kong  Gang Hu 《Marine pollution bulletin》2014

Samples of surface sediment and vibrocore were collected in the near-shore area of north Jiangsu Province for grain size, elements, ²¹⁰Pb_excess and ¹³⁷Cs analyses. In our study area, the diversity of metal concentration was controlled not by the grain size, but by the source. The element content of the old Yellow River Delta was used as baseline for our study area. Geoaccumulation indexes indicate that no station was polluted by Cu, Pb, Zn and As, but the I_geo values of As were close to zero in some stations. Slight pollution caused by Cd was observed in some stations. Correlation and enrichment factors suggest that Cu, Pb and Zn are lithogenic in origin, while As and Cd are mixed in origin. Especially, in some polluted stations Cd was obviously anthropogenic in origin.  相似文献   

Distributions of polycyclic aromatic hydrocarbons and alkylated polycyclic aromatic hydrocarbons in Osaka Bay,Japan     

Shizuho Miki  Seiichi Uno  Kazuki Ito  Jiro Koyama  Hiroyuki Tanaka 《Marine pollution bulletin》2014

Contaminations in sediments by polycyclic aromatic hydrocarbons (PAHs) and alkylated PAHs were investigated at 44 sites in Osaka Bay, Japan. Concentrations of total PAHs and alkylated PAHs were in the range 6.40–7800 ng/g dry weights and 13.7–1700 ng/g dry weights, respectively. The PAH concentrations tended to be higher along the shoreline in the vicinities of big ports, industrialized areas, and densely populated regions such as the cities of Osaka and Kobe. The major sources appeared to be pyrogenic or both pyrogenic and petrogenic at most of the sites. PAH concentrations were remarkably high at a site near Kobe, where the concentrations of dibenzo(a,h)anthracene and benzo(g,h,i)perylene exceeded the effects-range-medium concentration and eight PAHs were above the corresponding effects-range-low concentrations. Those PAHs may have been derived from the great fire associated with the large earthquake in 1995.  相似文献   

夏季亚洲季风区对流层-平流层不可逆质量交换特征分析   总被引：1，自引：1，他引：0       下载免费PDF全文

陈斌  徐祥德  卞建春  施晓晖 《地球物理学报》2010,53(5):1050-1059

基于2005年NCEP/GFS分析资料和拉格朗日粒子扩散模式的“Domain Filling”技术,以气块穿越对流层顶后的滞留时间为标准,诊断分析了夏季亚洲季风区对流层-平流层质量交换,重点讨论了对平流层大气成分收支具有实际意义的不可逆双向质量交换过程,并利用前向（后向）轨迹追踪方法,分析了其4天的“源（汇）”特征.研究结果表明：(1)对流层-平流层质量交换(Troposphere-Stratosphere mass Exchange,STE)的计算对滞留时间阈值的选择具有较强敏感性,大多数的气块在1～2天内可频繁地往返对流层顶.这些瞬时交换事件的考虑与否对穿越对流层顶的质量交换计算的准确性具有重要影响,尤其在中纬度的风暴轴区域.(2)从亚洲季风区对流层-平流层质量净交换纬向平均上看,45°N以南的区域为对流层向平流层的质量输送(Troposphere to Stratosphere mass Transport,TST),副热带地区为最强的上升支,而在45°N~55°N的中纬度地区是平流层向对流层质量输送（Stratosphere to Troposphere mass Transport,STT）.地理分布上,STT主要分布在青藏高原以北的东亚地区,与亚洲季风区夏季大尺度的槽区相对应.夏季整个亚洲季风区都是TST发生的区域,最大值位于青藏高原东南侧及其附近区域,该区域占亚洲季风区不可逆TST夏季平均总量的46%.(3)对流层-平流层质量交换的“源汇”特征分析表明,STT主要源于100°E以西、50°N以北的高纬地区,向下可以输送到中国东北部及朝鲜半岛北部等中纬度区域.而TST主要来源于中纬度和副热带地区的大气输送,向上穿越对流层顶高度以后,可分别向高纬的极地和热带地区输送,这意味着亚洲季风区夏季的TST水汽输送可能进入“热带管”中,进而可能对全球平流层水汽平衡产生重要影响.  相似文献   

Comparison of alternative upscaled model formulations for simulating DNAPL source dissolution and biodecay     

Jack C. Parker  Ronald W. Falta 《Advances in water resources》2008

This paper compares the performance of analytical and numerical approaches for modeling DNAPL dissolution with biodecay. A solution derived from a 1-D advective transport formulation (“Parker” model) is shown to agree very closely with high resolution numerical solutions. A simple lumped source mass balance solution in which with decay is assumed proportional to DNAPL mass (“Falta1” model) over- or underpredicts aqueous phase biodecay depending on the magnitude of the exponential factor governing the relationship between dissolution rate and DNAPL mass. A modification of the Falta model that assumes decay proportional to the source exit concentration is capable of accurately simulating source behavior with strong aqueous phase biodecay if model parameters are appropriately selected or calibrated (“Falta2” model). However, parameters in the lumped models exhibit complex interdependencies that cannot be quantified without consideration of transport processes within the source zone. Combining the Falta2 solution with relationships derived from the Parker model was found to resolve these limitations and track the numerical model results. A method is presented to generalize the analytical solutions to enable simulation of partial mass removal with changes in source parameters over time due to various remedial actions. The algorithm is verified by comparison with numerical simulation results. An example application is presented that demonstrates the interactions of partial mass removal, enhanced biodecay, enhanced mass transfer and source zone flow reduction applied at various time periods on contaminant flux reduction. Increasing errors that arise in numerical solutions with coarse discretization and high decay rates are shown to be controlled by using an adjusted decay coefficient derived from the Parker analytical solution.  相似文献   

1998~2003年伽师三次不同类型M_s6级地震震源破裂过程及短期内余震活动特征          下载免费PDF全文

赵翠萍  陈章立  郑斯华 《地球物理学报》2008,51(4):1093-1102

利用大量远场观测地震图反演了新疆伽师地区三次不同机制类型M_s6级地震的破裂过程.结果表明,1998年8月2日M_s6.1级地震破裂尺度小,破裂过程简单,最大滑动量为12 cm,主破裂过程持续时间为8 s.1998年8月27日M_s6.5地震破裂过程的空间分布反映出双侧破裂特征,主破裂过程在前13 s基本完成,最大滑动量为63 cm,破裂面上起始破裂点两侧的滑动矢量方向不同.2003年2月24日M_s6.8地震的破裂过程最为复杂,震源时间函数由两次上升时间组成,破裂一共持续了32 s,最大滑动量为32 cm.研究表明,余震主要发生在主震破裂图像中大滑动量区域的外围或滑动量变化梯度较大的区域,主震后短期内发生的余震震源机制解也与破裂面上断层的错动方向一致,表明余震的位置和机制与主震破裂所引起的应力重新分布有关.  相似文献   

Tracing suspended sediment and particulate phosphorus sources in catchments   总被引：4，自引：0，他引：4  

D.E. Walling  A.L. Collins  R.W. Stroud 《Journal of Hydrology》2008,350(3-4):274-289

Information on suspended sediment and particulate P (PP) sources is an important requirement in many catchment-based diffuse source pollution studies, in order to assist with model validation and to provide information to support the development of effective sediment and phosphorus control strategies. Such information is, however, frequently unavailable or difficult to assemble. In the study reported, source fingerprinting procedures were successfully used to assemble this information for seven sub-catchments in the Hampshire Avon catchment and five sub-catchments in the Middle Herefordshire Wye catchment. The results provide important new information on the relative importance of the contributions from surface and channel/subsurface sources to the suspended sediment and PP fluxes from the catchments. In the Wye sub-catchments channel/subsurface sources contributed 40–55% of the overall suspended sediment flux and 21–43% of the PP flux from the catchments. Equivalent values for the Avon were 1–41% and 1–54%, respectively. Combination of the information on the relative importance of surface and channel/subsurface sources with measured suspended sediment fluxes has provided the first estimates of the specific fluxes of sediment and PP attributable to channel/subsurface sources for UK catchments. The former are as high as 15–20 t km⁻² year⁻¹ in some of the Wye sub-catchments, whereas the latter exceeded 0.1 kgP ha⁻¹ year⁻¹ in the same sub-catchments. The results emphasize the need to take account of potential contributions from channel/subsurface sources when using measured suspended sediment and PP flux data to validate predictions derived from models incorporating only surface contributions.  相似文献   

A seismological overview of long-period ground motion   总被引：1，自引：1，他引：0  

Kazuki Koketsu  Hiroe Miyake 《Journal of Seismology》2008,12(2):133-143

Long-period ground motion has become an increasingly important consideration because of the recent rapid increase in the number of large-scale structures, such as high-rise buildings and oil storage tanks. Large subduction-zone earthquakes and moderate to large crustal earthquakes can generate far-source long-period ground motions in distant sedimentary basins with the help of path effects. Near-fault long-period ground motions are generated, for the most part, by the source effects of forward rupture directivity. Far-source long-period ground motions consist primarily of surface waves with longer durations than near-fault long-period ground motions. They were first recognized in the seismograms of the 1968 Tokachi-oki and 1966 Parkfield earthquakes, and their identification has been applied to the 1964 Niigata earthquake and earlier earthquakes. Even if there is no seismogram, we can identify far-source long-period ground motions through the investigation of tank damage by liquid sloshing.  相似文献   

广州市主要断裂带特征震源模型研究     

赵伯明 《华南地震》2008,28(4):1-8

在广州市目标区内的主要活动断层危险性评价的基础上,综合活断层探测的研究成果和资料,对于具有潜在发震可能的主要断层,基于凹凸体震源模型建模理论进行了特征计算模型的建模。根据断层地震危险性分析确定的断层发震震级和几何参数,进行了断层的宏观参数和微观参数的设定。为通过复核预测方法计算与合成近断层强地震动场和城市危害性评价提供了科学的依据。  相似文献